Advertisement
Quick Links
R 1 7 3 0 R E M O T E C O N T R O L O P E R AT I N G I N S T R U C T I O N S
PROG button
TO CLEAR THE MOTOR:
Press and hold the blue button on the motor until the motor beeps 3 times and then jogs. Keep holding the blue
button and the motor will beep a further 3 times and jog. Stop pressing the blue button and the motor will jog
once more.
CONTROL RANGE
Transmission distance may be affected by the
environment.
120V/60Hz
220V/60Hz
230V/50Hz
DRIVE ADAPTER INSTALLATION
1)
INSTALLATION
Manufacture the blind according to
instructions and fit complete blind using
brackets supplied.
WIRING INSTALLATION
Unit must be connected to electricity
supply by a qualified electrician.
1
2
3
230V/50H z
220V/60H z
For use with R1740 Motor (6000 Series)
Motorised
roller blind
L1 open
L2 Partition
200m
35m
2)
ATTENTION
Shape the wire as above to avoid condensation damage.
Blue = Neutral
Brown = Live
Green/Yellow = Earth
L1
Emission Frequency
433.92MHz
Fix motor plate
Motorised
roller blind
L2
3)
Insert into roller
tube
Advertisement
Related Manuals for Louvolite R1730
Summary of Contents for Louvolite R1730
- Page 1 R 1 7 3 0 R E M O T E C O N T R O L O P E R AT I N G I N S T R U C T I O N S For use with R1740 Motor (6000 Series) PROG button TO CLEAR THE MOTOR: Press and hold the blue button on the motor until the motor beeps 3 times and then jogs.
- Page 2 Screen Up Button Stop Button Down Button Channel < Channel > Setting Button Setting Button (P2) (P2) PAIRING THE HANDSET WITH THE MOTOR 1. Select the channel to be paired. 2. Power up the motor. 3. Press the blue button on the motor to select pairing mode, the motor will beep and jog once. 4.
- Page 3 SETTING A MIDPOINT 1. Move the blind to the position to be set. 2. Press P2 the motor beeps and jogs. 3. Press STOP the motor beeps and jogs 4. Press STOP the motor beeps 3 times and jogs 3 times, this confirms setting. DELETING THE MIDPOINT 1.
- Page 4 6. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 7.