Page 2
Verify all parts are present 1. (x1) Ramp with hangers and climbing holds and undamaged attached 2. (x2) Triangle support brackets 3. (x2) Six (6) rung uprights 4. (x2) Seven (7) rung uprights 5. (x13) Rungs Not Pictured: 6. (x16) 1.5 in long, ¼-20 flat head screws 7.
Page 3
Place one (1) short upright and one (1) Assemble rungs long upright on your assembly surface with the circular pockets facing up. to uprights Insert rungs in alternating color in the manner shown below www.HeartwoodandHazel.com | HeartwoodandHazel@gmail.com...
Page 4
Place matching uprights, circular pocket down, on top of Attach rungs the rungs.* to uprights Place eight (8) 1.5” screws (four (4) in each upright) as shown. This will leave 3 empty holes on the long upright and 2 empty holes on the short upright. Snug screws but do not tighten! Flip both ladders over and repeat the above step inserting eight (8) additional screws...
Page 5
Before tightening all screws lay both Check assembled ladders flat and ensure that they are not twisted. The below image shows a slight ladders for flatness twist. If your ladders have a slight twist, you can lift the opposite corners to correct it. If you are unable to obtain a completely flat ladder, it will not affect the performance of your triangle and you can continue with...
Page 6
Lay both ladders on their side with the empty screw holes Assemble triangle facing each other as shown. Place a Support Bracket on top (with coutersunk holes facing up), aligning the three support brackets to holes in the empty ladder holes as shown below. Place five (5) 2”...
Page 7
Ramp can be placed in any orientation and Place ramp on triangle in on any rung depending on the needs and capabilities of your toddler. Experiment climbing orientation with steeper slopes and give them a challenge! or slide orientation www.HeartwoodandHazel.com | HeartwoodandHazel@gmail.com...
Page 8
Folding for storage or To fold the triangle for storage or transportation transportation, remove the screw from the position indicated below, swing the ladder until the ladders are parallel and re-insert the screw into the aligned hole as seen below. www.HeartwoodandHazel.com | HeartwoodandHazel@gmail.com...
Need help?
Do you have a question about the Hazel MONTESSORI CLIMBING TRIANGLE and is the answer not in the manual?
Questions and answers