Garland XTRIM 575 E Instruction Manual page 34

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 22
English
7. MACHINE USAGE
Only use this machine for applications for which
it has been designed. The inappropriate use of this
machine is dangerous and may cause damage to the
user or machine.
Work only in daylight or with adequate artificial light.
Do not use this machine at night, with fog or
with a low visibility that does not allow you to see
clearly in the work area
Limit the time of use of the device to 10 minutes, and
take a 10-20 rest between each session.
Avoid operating the machine when the soil is wet
whenever possible. Be especially careful if you use the
machine after it has been raining, since the ground
may be wet and you might slip.
If you slip, lose your balance, or fall release the ON/
OFF switch immediately.
Do not use this machine if you are tired, sick, under
the influence of drugs drugs, narcotics or alcohol.
Fatigue and lack of rest can cause accidents or
damage.
Always readjust the machine on a flat and stable
surface.
Do not use this machine on slopes where your safety
is not guaranteed. If you are working on a sloped
surface, slow down and make sure you are well
balanced and stable.
Stay away from the blade when the device is in
motion.
Do not only rely on the safety devices of this
machine.
It is vital to pay attention to the possible loosening
or overheating of the different parts of the machine.
If you detect anything unusual, stop the machine
immediately and check it carefully. In case of
malfunctions, take the machine to be repaired. You
should never continue to work with this machine if you
detect any problems.
Remember to always use the machine with clean
hands, rather than greasy or oily hands.
Do not use pieces on this machine except those
recommended by our company since they may cause
damage to the user, to anyone close to the machine
and to the machine itself.
Always follow the safety instructions given in this
manual.
7.1. SAFE HANDLING OF THE MACHINE
Hold the machine with your left hand on the handle
and the right hand positioned so that it can access the
On/Off switch.
Warning!: to reduce the risk of losing control
and damaging (including death) the user or nearby
persons, never use this machine with only one hand.
7.2. STRING HEAD CUTTING
Warning! Wear eye protection at all times. Do not
look directly into the cutting line since the pieces may be
projected while cutting which can cause serious wounds
in the face and the eyes. If the head hits a stone or any
other object, stop the engine and check its status. Do
not use damaged or poorly balanced pieces.
Hold the string trimmer so the head doesn't touch the
ground, at an angle of about 20 ° in the
direction in which it is being cut.
34/124

Advertisement

Table of Contents
loading

Table of Contents