Konig SAS-IPCAM100B Manual page 3

After the software installation is
2
complete, click the icon to run the app.
Default "uCare Cam" password: 0000
Manager's Name: admin
Manager's Password: 0000
There are two options to continue the easy set up of your IP camera.
Install your IP camera by ROUTER MODE
Power On
1
Plug the power adapter DC connector into the DC input port of the IP
camera and then plug the power adapter into a wall outlet. The status
LED on the IP camera will turn green for about 15 seconds.
Programme Loading
2
The status LED will flash red for about 15 seconds.
Router Link Mode
3
Wait until the status LED colour alternates between red and green.
Note:
If the LED does not turn red and green, then press the WPS/Reset
button for more than 10 seconds to restart the IP camera.
When the green status LED lights up and holds, and then the red status
LED flashes twice, after which it changes into green, the IP camera has
entered the RESET state. At this moment you can release the button
and then wait until the status LED alternates between red and green.
ANDROID (for Apple go to: Step 8)
Set the IP camera to connect to the Wi‑Fi Router
4
Open the "uCare Cam" App and select:
Click here to install the new Wi-Fi Camera:
In the screen of the Camera List Window (see Figure 1).
Figure 1
"Camera List Window"
3
ENGLISH