Konig SAS-CLALIPC10 - Wi-Fi Camera Quick Start Guide

1. Lens
2. Antenna
3. LED indicator
4. Ethernet connection
5. Power adapter connection
6. Memory card slot

Pairing the Wi-Fi camera

• Connect the camera to the router using the Ethernet cable.
• Connect the camera to the wall socket using the power adapter. The LED indicator comes on.
  Note: Do not start the pairing process until LED indicator is on.
• Open the app "Smart Home Security".
• Tap the icon.
• Select "Camera" to pair the camera to the gateway. The app will search for the camera and enter the camera ID.
  Note: If the app cannot find the camera, check whether the camera is switched on and the Ethernet cable is connected to the Wi-Fi router. You can also enter the camera ID and the camera password manually. The camera ID is located on the camera. The default password is "123456".
• Enter the device name ("Device Name") and the location ("Location").
• Tap "Save" to complete the pairing process. The camera is shown on the status page in the app.

For wireless connection:

• Add the Wi-Fi router to the app:
  • Tap "Status".
  • Tap the icon.
  • Tap the icon.
  • Tap the icon.
  • Enter the camera password to access the advanced settings ("Advanced Settings").
  • Select "WiFi".
  • Select the Wi-Fi router and enter the router password.
    The camera will reboot. The LED indicator comes on.
  • Disconnect the Ethernet cable from the camera and the router.

To verify the setup:

• Tap the icon of the camera on the status page in the app to see live view.

Technical data

Safety

RISK OF ELECTRIC SHOCK
DO NOT OPEN

• To reduce risk of electric shock, this product should only be opened by an authorized technician when service is required.
• Disconnect the product from the mains and other equipment if a problem should occur.
• Read the manual carefully before use. Keep the manual for future reference.
• Only use the device for its intended purposes. Do not use the device for other purposes than described in the manual.
• Do not use the device if any part is damaged or defective. If the device is damaged or defective, replace the device immediately.

Cleaning and maintenance

• Do not use cleaning solvents or abrasives.
• Do not clean the inside of the device.
• Do not attempt to repair the device. If the device does not operate correctly, replace it with a new device.
• Clean the outside of the device using a soft, damp cloth.