Table of Contents
Advertisement
AXIS M30 Network Camera Series
Configure your device
Record and watch video
Record video directly from the camera
1. Go to Video > Image.
2. To start a recording, click
If you haven't set up any storage, click
network storage on page 10
3. To stop recording, click
Watch video
1. Go to Recordings.
2. Click
Set up rules for events
You can create rules to make your device perform an action when certain events occur. A rule consists of conditions and actions.
The conditions can be used to trigger the actions. For example, the device can start a recording or send an email when it detects
motion, or show an overlay text while the device is recording.
To learn more, check out our guide Get started with rules for events.
Trigger an action
1. Go to System > Events and add a rule. The rule defines when the device will perform certain actions. You can set
up rules as scheduled, recurring, or manually triggered.
2. Enter a Name.
3. Select the Condition that must be met to trigger the action. If you specify more than one condition for the rule, all of the
conditions must be met to trigger the action.
4. Select which Action the device should perform when the conditions are met.
Note
If you make changes to an active rule, the rule must be turned on again for the changes to take effect.
Record video when the camera detects an object
This example explains how to set up the camera to start recording to the SD card when the camera detects an object. The recording
will include five seconds before detection and one minute after detection ends.
Before you start:
•
Make sure you have an SD card installed.
1. Start the application if it is not already running.
2. Make sure you have set up the application according to your needs.
Create a rule:
1. Go to System > Events and add a rule.
.
again.
for your recording in the list.
and
. For instructions on how to set up network storage, see Set up
11
Advertisement
Table of Contents
