Table of Contents
Advertisement
Available languages
Available languages
en Installation instructions
15.1 Safe installation
Follow these safety instructions when in-
stalling the appliance.
The appliance can only be used safely if it is
correctly installed according to the safety
instructions. The installer is responsible for
ensuring that the appliance works perfectly at
Check the appliance for damage after
unpacking it. Do not connect the appliance if
.
it has been damaged in transit
Before starting up the appliance, remove any
packaging material and adhesive film from
.
the cooking compartment and the door
Never remove the transparent film on the
Proceed in accordance with the installation
.
sheets for installing accessories
Fitted units must be temperature-resistant up
to 90 °C, and adjacent unit fronts up to
Do not install the appliance behind a
decorative door or the door of a kitchen unit.
.
There is a risk of overheating
Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct
operation of electrical components may be
Only a licensed professional may connect
appliances without plugs. Damage caused by
incorrect connection is not covered under the
WARNING ‒ Risk of injury!
Parts that are accessible during installation
may have sharp edges and may lead to cut-
ting injuries.
▶ Wear protective gloves
WARNING ‒ Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use extension cables or multiple
socket strips.
40
.
its installation location
.
inside of the door
.
65 °C
.
adversely affected
.
warranty
15.2 Electrical connection
In order to safely connect the appliance electrically, fol-
low these instructions.
WARNING ‒ Risk of electric shock!
Incorrect installation is dangerous.
Only a qualified electrician may route the socket or
▶
replace a power cable while taking into considera-
tion the applicable regulations.
Connect the appliance only to a correctly installed,
▶
earthed socket.
If the plug is no longer accessible following installa-
▶
¡
tion, an all-pole isolating unit with a contact clear-
ance of at least 3 mm must be available on the in-
stallation side. Contact protection must be ensured
by the installation.
15.3 Scope of delivery
¡
After unpacking all parts, check for any damage in
transit and completeness of the delivery.
¡
¡
¡
¡
¡
15.4 Fitted units
¡
Here, you can find notes on safe installation.
ATTENTION!
Any shavings may impair the function of electrical com-
ponents.
Carry out cut-out work on the units before installing
▶
the appliance.
¡
Remove the shavings.
▶
¡ The minimum installation height is 850 mm.
¡ The installation cabinet must not have a back panel
behind the appliance.
¡ The ventilation slots and intake openings must not
be covered.
¡ Fitted units must be heat-resistant up to 90 °C, and
adjacent unit fronts up to 65 °C.
Advertisement
Table of Contents
