Table of Contents
Advertisement
6.4
Links
The sensors and actuators created via the allocation function can now be linked with each
other. This allows simple switch-off circuits or two-way circuits to be implemented.
Linking is made via the linking function of the Web-based user interface of the
System Access Point.
Notice
For pre-programmed devices (switch actuator units) a link is automatically
established between actuator and sensor, since they are combined in the one
device.
6.4.1
Linking actuator and sensor
Fig. 18:
Linking actuator and sensor
1. On the working area select the sensor [1] that is to be linked with the actuator.
2. Select the actuator [2] that is to be operated by the sensor.
3. Press the tick at the bottom right [3] to take over the entries.
A blue connecting line indicates the link between the two devices. The configuration is
transmitted automatically to the devices. The transmission can, depending on the number of
affected devices, take a number of seconds. During the transmission a progress bar is
displayed around the devices affected.
Product manual 2CKA001473B9189
Commissioning
│27
Advertisement
Table of Contents
