Set Up And Programming - Stealth Cam WD2IR User Manual

out the card gently.
SD cards must be clean (no images from other sources), if
you are using the SD card from other cameras, please
make sure to format the SD card prior use in the STC-WD2-
IR (See format section on page 18). New cards are good
to use straight from the package.

Set up and Programming

When the camera is first turned on the internal LCD screen
displays the camera status. The following information is present
on this screen.
If no buttons are pressed after 30 seconds the LCD screen will
power down to conserve battery life and enter 1 minute count
down to enter PIR detection mode. To re-power the display
screen press and hold the UP or DOWN button for at least 5
seconds.
www.stealthcam.net
STC-WD2-IR
Toll Free 877-269-8490 12