Removing and mounting the attachments
• Take care not to injure hands, etc., with the blade
when removing or mounting the attachment.
Removing the attachment
►
Hold the main body
securely and pull the
attachment out upward
and remove it from the
main body.
• Hold the rib (
) part
a
securely and remove
the detail trimming
attachment.
Mounting the attachment
►
Mount the attachment to
the main body until it
clicks.
• If the attachment is not
attached correctly, it
may shift and end up
cutting too much during
use.
• You can follow the same procedure to remove
and mount the protective cap.
PB018141 - ER-GD61
_(01GB)_08-30-19.indd 11
Without attachment
• Use without the attachment for design precise lines.
Place the blade horizontally against the skin and
towards the beard line trim slowly.
a
Trimming height: approx. 0.1 mm
(Fixed blade thickness is 0.1 mm)
Trimming height comb attachment
• The digit on the attachment indicates the target
trimming length.
• Actual beard length will be a little longer than the height
you set.
• The desired results may not be achieved if beard is too
long.
Click
In this case, trim the beard to a length of about 20 mm
before using the appliance.
• Beard will be easy to accumulate in the attachment
when a lot of beard is cut. When this happens, clean
the attachment. (See pages 12 and 13.)
11
2019/8/30 14:18:35