Table of Contents
Advertisement
Search for Channels
You can reinstall all channels and leave all other TV
settings untouched.
If a PIN code is set, you will need to enter this code
before you can reinstall channels.
To Search for Channels...
1 - Press Home > Settings > Install
channels and press OK.
2 - Select RF Channel Installation and press OK.
3 - Enter your PIN code if necessary.
Select Search for Channels and press OK.
Select Start and press OK.
Select the country where you are now and press OK.
Select Start and press OK.
Select the type of installation you want, Antenna
(DVB-T) or Cable (DVB-C) and press OK.
Select Next and press OK.
Select the type of channels you want, Digital and
Analogue Channels or Only Digital Channels and
press OK.
Select Next and press OK.
Select Start and press OK to update the digital
channels. This can take a few minutes.
Press (left) to go back one step or press BACK
to close the menu.
Automatic Channel Update
If you receive digital channels, you can set the TV to
automatically update these channels.
Once a day, at 6 AM, the TV updates the channels
and stores new channels. New channels are stored in
the Channels List and are marked with a .
Channels without a signal are removed. The TV must
be in standby to automatically update channels. You
can switch off Auromatic Channel Update.
To switch off the automatic update...
1 - Press Home > Settings > Install
channels and press OK.
2 - Select RF Channel Installation and press OK.
3 - Enter your PIN code if necessary.
4 - Select Automatic Channel Update and
press OK
5 - Select Off and press OK.
6 - Press (left) to go back one step or
press BACK to close the menu.
Channel Update Message
When new channels are found or if channels are
updated or removed, a message is shown at TV start
up. To avoid this message to appear after every
channel update, you can switch it off.
To switch off the message...
1 - Press Home > Settings > Install
channels and press OK.
2 - Select RF Channel Installation and press OK.
3 - Enter your PIN code if necessary.
4 - Select Automatic Channel Update and
press OK
5 - Select Off and press OK.
6 - Press (left) to go back one step or
press BACK to close the menu.
In certain countries, the Automatic channel update is
done while watching TV or on any moment when the
TV is in standby.
Digital: Manual Installation
Digital TV channels can be manually installed,
channel by channel.
To install digital channels manually...
1 - Press Home > Settings > Install
channels and press OK.
2 - Select RF Channel Installation and press OK.
3 - Select Digital: Manual Installation and
press OK.
4 - Select Search and press OK. You can enter a
frequency yourself to find a channel or let the TV
search for a channel. Press (right) to
select Search and press OK to search for a channel
automatically. The found channel is shown on screen
and if the reception is poor, press Search again. If
you want to store the channel, select Done and
press OK.
Analogue: Manual Installation
Analogue TV channels can be manually installed,
channel by channel.
To install analogue channels manually...
1 - Press Home > Settings > Install
channels and press OK.
2 - Select RF Channel Installation and press OK.
3 - Select Analogue: Manual Installation and
press OK.
• System
To set up the TV system, select System.
Select your country or the part of the world where
you are now and press OK.
• Search Channel
To find a channel, select Search Channel and
press OK. You can enter a frequency yourself to find
a channel or let the TV search for a channel.
Press (right) to select Search and press OK to
search for a channel automatically. The found
channel is shown on screen and if the reception is
28
Advertisement
Table of Contents
