Sylvania LC320SS2 Manual page 27

USB Storage Device
This unit offers easy playback of JPEG picture fi les.
Insert the USB storage device into the USB terminal shown
➠
below. [USB] p. 24
Note
• The unit recognizes only a USB storage device.
• Do not use a USB hub or an extension cable to connect an
external hard disk drive to the unit. (Not supported.)
• A USB storage device is always inserted to this unit directly.
• A USB storage device is not supplied with this unit.
• We do not guarantee that all USB storage devices can be
supported by this unit.
• Be sure to keep a backup copy of the original fi les on your device
before you play them back on this unit. We have no responsibilities
for damage or loss of your stored data.
• To protect your USB storage device fi les from being erased place
the write protect sliding tab in the protect position.
• When you are ready to remove a USB storage device, at fi rst turn
the unit off so it will go into standby mode to avoid any damage
to your data and the unit.
• A USB storage device that requires its own driver or the device
with a special system such as fi ngerprint recognition are not
supported.
• This unit is not allowed to use the USB storage device which
requires an external power supply (500mA or more).
• Up to 2GB (FAT16) or 8GB (FAT32) capacity can be supported.
• Only USB 2.0 is supported.
• Up to 10,000 fi les or 1,000 folders with 19 hierarchies can be
recognized.
• Up to 255 English characters can be recognized.
• This unit does not support MTP(Media Transfer Protocol).
• This unit supports FAT16 and FAT32 fi le systems.
• If the fi le is not supported, an error message appears.
• When the USB storage device is not recognized, try reconnecting
it again.
It is recommended that files to be played back in this unit are
recorded under the following specifications:
• Upper limit : 24 Megapixel
27
English