OPERATING INSTRUCTIONS FOR THE CHARNWOOD LA45iB & LA50iB GENERAL POINTS will be able to advise you if other fuels output is controlled by the control may be burnt. For instructions on knob on the left hand side of the Before lighting the fire check with the burning other fuels please ask your appliance, shown in Fig.
To make ash removal easier there is a closed. special Charnwood ash carrier available. This may be purchased from Fig. 2. Secondary Air Control OVERNIGHT BURNING Empty the ashpan, if necessary, and...
period until the fire is burning brightly thermostat should be left at the MAINTENANCE before filling with fuel. maximum setting and the main doors Cleaning left ajar. It is also advisable to sweep If the central heating pump is off The appliance is finished in vitreous the chimney and clean out the fire.
insulated chimneys the manufacturers a) the door seals are kept in good sought if necessary. instructions with regard to sweeping condition, and that the doors are should be consulted. sealing correctly, b) the thermostat on the fire is working correctly, BOILER REDUCTION BRICK Lack of Heat To c) a suitable fuel is being used,...
This must be borne in the complete chimney. The rated output for the LA45iB is mind when calculating the heating 10.1 kW (34500 btu/h) to water and If it is found that there is excessive requirements.
combustible material. The positioning be reduced. Fig. 5. shows the ratio of of the appliance and the size of the space heating to water heating which hearth are governed by building can be expected. regulations for Class 1 appliances. Fitting a radiator in the same room as These building regulations state that the fire is recommended as it will allow the hearth must extend in front of the...
length of 150mm (6”) internal 22mm Open Vents diameter flue pipe (cast iron to BS41, Feed and Expansion Tank Cold Water Tank 1.0 mm thick stainless steel, or 5.0mm thick mild steel). Overflow Overflow The end of the flue pipe must line up with the centre-line of the chimney, and must also extend to the point where Domestic Hot Water Draw Off...
On completion of the installation and the air inlet as shown in Fig. 12. To operated. commissioning please leave the adjust the distance slacken the locking 2. The plates round the sides and back operating instructions with the nut and adjust as necessary. When set of the grate must be in position and customer and advise on the use of the correctly re-tighten the locking nut.
Issue L CHARNWOOD LA45iB & LA50iB PARTS LIST Freestanding Kit Nuts, bolts, screws and clips are not shown for clarity. To obtain spare parts contact your local stockist giving Model, Part No. and Description. In case of difficulty contact the manufacturer at the address shown below.