Troubleshooting
Problem / Symptom
Only plug turntables into this input, do not plug in
Sound is distorted
CD players or other Line Level sources. Turn down
Phono Input
the INPUT GAIN CONTROL
Make sure you are using good shielded audio
cables. Some less expensive audio cables can be
susceptible to hum and interference. Keep your
audio cables away from AC power cables and AC
I hear hum.
transformers. Make sure the mixer is not mounted
too close to high power amplifiers or lighting
equipment power supplies or ballasts. Make sure
your turntables are properly
grounded.
If you are using a microphone, make sure that
you are not too close to the speakers or
headphones. If you hear feedback on the phono
I hear
input, then the turntable may be mounted to close
to the speakers. Also, make sure the turntable
feedback
base is placed on a surface that does not vibrate
or resonate easily when the speakers are turned
up loudly.
Warranty
This unit has been designed and manufactured using quality components.
Therefore, it is warranted to be free from defects in materials (limited as specified
below), and workmanship for a period of twelve (12) months from the original
purchase date. During this period, all service and parts
necessary to repair a defect will be free of charge. This limited warranty applies to
mechanical parts which are subject to wear and tear as specified:
• Faders, specified durability: 15,000 cycles
• Rotary potentiometers, specified durability: 10,000 cycles
• Switches, specified durability: 10,000 cycles
Consequently, the parts listed above are warranted to be free from defects in materi-
als and workmanship for a period of thirty days (30) days from the original purchase
date.
FOR THE WARRANTY TO BE VALID, PLEASE COMPLETE THE ONLINE
WARRANTY REGISTRATION FORM FOUND AT
WWW.STANTONMAGNETICS.COM
© 2003, Stanton Magnetics, LLC
Possible Cause/ Solution
Professional DJ Mixer
RM-22
OWNER'S M A N U A L
STANTON MAGNETICS, LLC
info@stantonmagnetics.com