M.T.H. RailKing R-17 Subway Set Operator's Manual page 15

Headlights
To replace the headlights and other
end-of-car lights in the powered unit:
1. Remove the shell as described in the
"Lubrication and Greasing" section of
this booklet.
2. Pull out the bulb shown in Figure 8
to replace the Number/Destination
Board bulb.
3. To replace the headlight bulbs,
remove the harness witht the blue 2 pin
connector shown in Figure 9.
4. To replace the top marker lights,
remove the harness with the yellow 2
pin connector shown in Figure 9.
5. To replace the marker lights below
the headlight, remove the harness with
the green 2 pin connector shown in
Figure 9.
Replacement bulbs and wire ties are
available directly from the M.T.H. Parts
Department (order online:
www.mth-railking.com, e-mail:
parts@mth-railking.com; mail: 7020
Columbia Gateway Drive, Columbia
MD 21046-1532, FAX: 410-381-6122).
RailKing R-17 Subway Set
Gently Pull Bulbs
Away From Socket To Remove
Figure 8
Unplug Marker Light Wires
From Socket To Remove
Figure 9
15