Shutting Off The Engine; Recycling The Clippings; Bagging The Clippings - Toro Recycler SmartStow 20340 Operator's Manual

and your elbows at your sides, and the machine will
automatically keep pace with you
Note:
If the machine does not freely roll forward
or backward after using the self-propel drive, stop
walking, hold your hands in place, and allow the
machine to roll a couple of centimeters (inches)
forward to disengage the wheel drive. You can also
try reaching just under the upper handle to the metal
handle and pushing the machine forward a couple
of centimeters (inches). If you are having issues
propelling in reverse, slightly lift the handle. If the
machine still does not roll backward easily, you may

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove it; refer to
16). If the bag-on-demand lever is in the recycling position, move it to the bagging position; refer to
the Bag-on-Demand Lever (page
Installing the Grass Bag
1. Raise and hold up the rear deflector (A of
2. Install the grass bag, ensuring that the pins on the bag rest in the notches on the handle (B of
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps in
(Figure 15).
Figure 15
15).
Installing the Grass Bag (page
need to adjust the self-propel drive; refer to
the Self-Propel Drive (page
an Authorized Service Dealer.

Shutting Off the Engine

Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important:
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop
using your machine immediately and contact an
Authorized Service Dealer.
g038503

Recycling the Clippings

Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position,
move the lever to the recycling position; refer to
Operating the Bag-on-Demand Lever (page
the side-discharge chute is on the machine, remove
it; refer to Removing the Side-Discharge Chute (page
16).
Removing the Side-Discharge Chute (page
Figure 16).
Figure 16
14
23). Otherwise, contact
When you release the blade-control
14).
Adjusting
15). If
Operating
Figure 16).
g233434