Table of Contents
Advertisement
Water hardness °E
39 - 62
Note: Set the water hardness determ-
ined on your appliance.
→ "Setting water softening system",
Page 29
With a water hardness of 0 - 8 °E
you can dispense with special salt
and switch off the water softening
system.
→ "Switching off water softening sys-
tem", Page 30
Setting water softening sys-
tem
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 28
Press
.
2.
Hold programme button A and
3.
press
repeatedly until the dis-
play shows H:xx.
Release programme button A and
4.
.
a Programme button A flashes and
the display shows H:04.
Press programme button C re-
5.
peatedly until the right water hard-
ness has been set.
Press
to save the setting.
6.
Special salt
You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The amount of spe-
cial salt required depends on the wa-
Hardness range
Hard
Water softening system en
mmol/l
5.5 - 8.9
ter hardness: the higher the water
hardness, the greater the amount of
special salt required.
ATTENTION!
¡ Detergent may damage the water
softening system.
Only fill the dispenser of the wa-
▶
ter softening system with special
dishwasher salt.
¡ Special salt can damage the tub
due to corrosion.
To make sure that any special
▶
salt that escapes is washed out
of the tub, add the special salt
to the dispenser for special salt
immediately before the pro-
gramme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Setting value
H:07
29
Advertisement
Table of Contents
