Table of Contents
Advertisement
The control panel
Touch controls
Switch the appliance on and off
#
Lock the control panel for cleaning
>
Activate the childproof lock
D
Select a hotplate
ø
Set the heat settings/set the ventilation sys-
0 1
Ç
2
Ç
...8
Ç
9
tem
Switch between the setting areas for the
:
hob and the ventilation system/reset the
saturation indicators
Activate the Move function
ù
Activate the Combi zone function
ú
Switch on the PowerBoost function for heat
à
settings/switch on intensive mode for the
ventilation system
Program the cooking time and kitchen
0
timer
Indicators/symbols
Operating status
Ú
Heat settings/fan settings
‚
-
Š
Residual heat
•
/
œ
Kitchen timer
V
Automatic hotplate switch-off/automatic
x
timer
Timer function
‹‹
Timer displays
ö
Metal grease filter saturation indicator
"‚ ‹
Activated charcoal filter saturation indicator
"‚ ‚
Touch controls
Touching a symbol activates the associated function.
Notes
Always keep the control panel clean and dry.
■
Moisture reduces its effectiveness.
Do not place any cookware near the indicators or
■
sensors. The electronics could overheat.
Getting to know your appliance
Residual heat indicator
The hob has a residual heat indicator for each hotplate.
This indicates that a hotplate is still hot. Do not touch a
hotplate while the residual heat indicator is lit up.
The following indicators are shown depending on the
amount of residual heat:
Display
: High temperature
•
■
Display
: Low temperature
œ
■
If you remove the cookware from the hotplate during
cooking, the residual heat indicator and the selected
heat setting will flash alternately.
When the hotplate is switched off, the residual heat
indicator will light up. Even after the hob has been
switched off, the residual heat indicator will stay lit for as
long as the hotplate is still warm.
Ventilation modes
This appliance can be used in air extraction or air
recirculation mode.
Exhaust air mode
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
If the exhaust air is conveyed through the external wall,
a telescopic duct should be used.
Air recirculation mode
The air that is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.
To bind odours in air recirculation mode, you
Note:
must install an activated carbon filter. The different
options for operating the appliance in air recirculation
mode can be found in the brochure. Alternatively, ask
your specialist dealer. The required accessories are
available from specialist retailers, from our after-sales
service or from our online shop.
en
11
Advertisement
Table of Contents
