Xiaomi Mi Motion-Activated Night Light 2 User Manual page 10

Precautions
Do not cover the detection area of the light.
When cleaning the surface of the light, wipe it clean with a soft cotton cloth and do not use
any corrosive solvents.
Do not install the light near heat sources such as AC or heating vents, or in direct sunlight.
Nor install the light near sources of humidity such as humidifiers or water heaters.
Make sure it is firmly installed with the magnet, so as to avoid the risk of accidental dropping.
Make sure the Mi logo is always upright when installing and using the night light.
When the brightness of the night light is reduced after a period of normal use, the battery
level may be insufficient. Please replace the batteries with new ones and dispose of the used
batteries in accordance with local rules and regulations, so as to avoid environmental
pollution.
The light source contained in this luminaire shall only be replaced by the manufacturer or his
service agent or a similar qualified person.
For indoor use only.
Please pay attention to the positive (+) and negative (-) poles when installing the batteries.
After non-rechargeable batteries are depleted, they cannot be charged. Different types of
batteries, and old and new batteries should not be mixed.
Remove leaking batteries from the night light and dispose of them in accordance with local
rules and regulations, so as to avoid environmental pollution.
The batteries must be removed from the night light when it is not used for a long time, or
when the night light is being disposed of.
Under normal use of condition, this equipment should be kept a separation distance of at
least 20cm between the antenna and the body of the user.
10