Philips AWH1620/51(30YC) User Manual page 10

Installation
1 The water heater should be installed
on a solid wall The wall on which the
electric water heater is to be installed
must be capable of supporting at least
twice the weight of the water heater
when fully filled with water, and the
wall must be free of cracks and other
damage Otherwise, it is necessary
to take measures to strengthen the
fastening or install the water heater on
a special support
2 If the bathroom is too small, the water
heater can be installed in another
place, closed from direct sunlight and
inaccessible to moisture However, to
reduce heat losses in the pipelines, the
installation site of the water heater
should be as close as possible to the point
of use of hot water
2
3*
4*
5*
fig
1 Power cord with plug and RCD
2 Hot water outlet
3 Hot water flow control tap*
4 Faucet*
5 Shower head*
6 Cold water inlet tap*
7 Drain tube
8 Combined safety valve
9 Cold water inlet
10 Dielectric coupling Static CARE
* Not included in the scope of delivery
8
9
6
7
3
Water heater installation methods
The installation method of the water
heater for one consumption point is shown
in fig. 3.
Attention!
The water heater must be installed on a
vertical wall in a strictly vertical position
Installing the device in any other position or
skew relative to the vertical will inevitably
lead to the failure of the water heater,
creating an emergency and is considered by
the manufacturer as a non-warranty case.
1
10
8