Checking The Engine-Oil Level; Checking And Adjusting The Skids And Scraper - Toro Power Max Heavy Duty 928 OAE Operator's Manual

Checking the Engine-Oil Level

Service Interval: Before each use or daily—Check the engine-oil level and add oil if necessary.
Checking and Adjusting the
Skids and Scraper
Service Interval: Yearly—Check the skids and
scraper and adjust them if
necessary.
Check the skids to ensure that the auger does not
contact the paved or gravel surface. Adjust the skids
as needed to compensate for wear.
1. Check the tire pressure; refer to
Adjusting the Tire Pressure (page
2. Loosen the nuts that secure both skids to the
auger sides until the skids slide up and down
easily (Figure 24).
Figure 24
1. 1.3 cm (1/2 inch)
3. Support the side plates so that they are at least
1.3 cm (1/2 inch) above a level surface.
Important:
The auger blades must be
supported above the ground by the skids.
4.
5.
6.
6 Checking and
7).
g001570
17
Ensure that the scraper is 3 mm (1/8 inch) above
and parallel to a level surface.
Note:
If the pavement is cracked, rough, or
uneven, adjust the skids to raise the scraper. For
gravel surfaces, adjust the skids further down to
prevent the machine from picking up rocks.
Move the skids down until they are even with
the ground.
Firmly tighten the nuts that secure both skids
to the auger sides.
Note:
To quickly adjust the skids if they loosen,
support the scraper 3 mm (1/8 inch) off the
pavement, then adjust the skids down to the
pavement.
Note:
If the skids become excessively worn,
you can turn them over and set the unused side
toward the pavement.
g257528