Advertisement
PTT3 Power Tugger
5
II. Safety
PTT3 Safety
Charge the batteries after using the PTT3 Tugger.
Always place the female coupling (1a) at the correct
height. It's important that the coupling is at the correct
angle and is firmly fastened to your trailer.
Raise / lift the coupling until the casters have enough
ground clearance (1.5").
Only lift the coupling high enough to perform the transport.
Load Placement
The image below shows the correct setup that should be used with the PTT3, as well as where to
place the load. These trailers should consist of one wheel axle. When the trailer and the PTT3's cou-
pling are attached to each other, and the PTT3's arm is raised, the trailer leg will be lifted off
the ground.
As mentioned above, trailers should consist of one wheel axle. If there are two axles and the floor is
uneven, the front wheel will be lifted up by the PTT3 and overload the wheels. Uneven floors put the
trailer coupling at risk of unfastening and can disconnect from the trailer.
Advertisement
