Table of Contents
Advertisement
Setting Name
Port
Directory
Encryption key
iSCSI ID
5. Expand the Status section.
Status section indicates if the iSCSI share was successfully mounted on the FortiRecorder unit's file system.
The
This field appears only after you configure the iSCSI share and click
Status may take some time to appear if the iSCSI server is slow to respond. If a
then the iSCSI share was not successfully mounted. Verify that the iSCSI server is responding and the
FortiRecorder unit has both read and write permissions on the iSCSI server.
6. Click Apply .
7. Go to Camera > Configuration > Camera Profile .
8. Select the camera profile used by cameras that should use remote storage, and then click Edit .
9. From
Storage
Options, select
10. Click Create .
Configuring email settings for notifications
If you want FortiRecorder to send email for notifications, and you want to use your own email server to send them, then
configure the settings that FortiRecorder will use to connect to your email server.
To configure notification email settings
FortiRecorder 7.0.0 Administration Guide
Fortinet Inc.
Description
Type the port number on which the server listens for connections.
The default is 2049 for NFS and 3260 for iSCSI.
This option only appears if
Enter the path of the folder on the server, relative to the mount point or user's
login directory, where the FortiRecorder appliance will store the data.
Note : Do not use special characters such as a tilde ( ~ ). This will cause the
storage to fail.
This option only appears if NFS is the selected protocol.
The key used to encrypt data stored on the iSCSI server. Valid key lengths are
between 6 and 64 single-byte characters.
This option only appears if
The iSCSI identifier in the format expected by the iSCSI server, such as an
iSCSI Qualified Name (IQN), Extended Unique Identifier (EUI), or T11
Network Address Authority (NAA).
This option only appears if
If the remote iSCSI device has not been formatted, before you can use it, you must format
it with the following CLI command:
execute storage format
Move .
In factory default settings, the mail relay server is:
notification.fortinet.net
iSCSI Server or NFS is the selected protocol.
iSCSI Server is the selected protocol.
iSCSI Server is the selected protocol.
Apply .
Not mounted message appears,
77
Advertisement
Table of Contents
