Advertisement
Using the PT-6000 with an IBM 469X computer with a projection
1. Install the PT-6000 onto the IBM 469X series so that the slot in the PT-6000 fits over the
projection on the host computer. It is not necessary to use the affixing tape.
2. Connect the cable and install the printer, aligning the rubber feet of the printer with the
proper locations on the PT-6000.
Installing the DPR-6000
Set the display module on the DPR-6000, which is also an option for the TM-H6000/H6000II/
H6000III printer and is in a separate package. The package includes the DPR -6000 and 2 bolts
with nuts. Remove the nuts from the bolts, insert the 2 bolts in the places shown below, and
replace the nuts and tighten them. Then attach the DPR-6000 to the host computer.
Installing the TA-6000
If you want to cover the space beside the printer, use the TA-6000, which is provided in a
separate package.
Space
Nut
Bolt
DPR-6000
Projection
TA-6000
Slot
Advertisement
