Meridian 220BST Operator's Manual page 42

3. Place spring (10) onto the pin of actuator arm
(11) and install washer nut (9) so the spring is
freeto rotate on the pin of actuator arm (11).
4. Position the actuator onto the mounting
bracket so that the four mounting holes are
aligned to the bracket (3).
a. Place spacers (8) between the actuator
and the bracket. Note that actuator arm
(11) is on the same level as the bracket.
42
b. If actuator arm (11) is below the bracket
(as shown), the arm will continue to rotate
and not function properly. The bracket
serves as a stop for the arm.
c. Install the four bolts (5), washers (6), and
lock nuts (7) as shown. Note that the
bolt nearest the engine is reversed, for
clearance, with the lock nut on top.
Note: The four spacers are all positioned under
the mounting plate no matter which direction the
bolt is installed.
5. Reinstall the cover.