Engine Circuit Protection; Engine Speed Setting - Meridian 220BST Operator's Manual

11.2.5 Engine Circuit Protection

The circuit protector protects the battery charging
circuit. A short circuit, or a battery connected with
reverse polarity, will trip the circuit breaker.
The green indicator inside the circuit protector
will pop out to show that the circuit protector has
switched off. If this occurs, determine the cause
of the problem, and correct it before resetting the
circuit protector.
Push the circuit protector button to reset.

11.3 ENGINE SPEED SETTING

WARNING
ROTATING PART HAZARD
The engine speed must be adjusted
with the engine running. Use extreme
caution when working near rotating parts.
To prevent serious injury from rotating
parts do not operate with rotating
parts exposed. Make sure the belt
guard is installed before adjusting the
engine speed.
40
Every engine is set with a high idle of 3000 RPM.
Before using the seed tender, check the RPM of
the auger drive pulley.
1. Start the engine. Use the throttle switch on
the delivery tube to set the engine to high idle
(full throttle).
2. Use a tachometer to check the large drive
pulley speed. The pulley should turn 200 RPM
at high engine speed.
3. Use a screwdriver to reset the high idle stop
screw if required to obtain the desired speed.