Worx Nitro WG325E Series Safety And Operating Manual
Cordless pruning saw
Hide thumbs
Also See for WG325E Series:
- Original instructions manual (260 pages) ,
- Original instructions manual (62 pages) ,
- User manual
Subscribe to Our Youtube Channel
Related Manuals for Worx Nitro WG325E Series
Summary of Contents for Worx Nitro WG325E Series
- Page 1 SAFETY AND OPERATING MANUAL ORIGINAL INSTRUCTIONS Cordless Pruning Saw WG325E WG325E.X...
-
Page 2: Table Of Contents
TABLE OF CONTENT carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or 1. SAFETY INSTRUCTIONS moving parts. Damaged or entangled cords increase the risk of electric shock. 2. COMPONENT LIST e) When operating a power tool outdoors, use an 3. - Page 3 turn it on and off. Any power tool that cannot batteries may exhibit unpredictable behaviour be controlled with the switch is dangerous and resulting in fire, explosion or risk of injury. must be repaired. f) Do not expose a battery pack or tool to fire c) Disconnect the plug from the power source or excessive temperature.
- Page 4 h) Carry the pruning saw by the front handle with are taken. Do not let go of the pruning saw. the pruning saw switched off and away from b) Do not overreach and do not cut above your body. When transporting or storing the shoulder height.
- Page 5 2˝ b) Do not short-circuit a battery pack. Do not limbs in one cut as illustrated in Figure 1. Branches store battery packs haphazardly in a box or under tension should be cut from the bottom up to drawer where they may short-circuit each avoid binding the pruning saw.
- Page 6 illustrated in Figure 4, cut 1/3 the diameter from the top (overbuck) (1). Then make the finished cut Wear eye protection by underbucking (2) the lower 2/3 to meet the first cut. Wear dust mask Wear head protection Beware of pruning saw kickback and avoid contact with bar tip Do not expose to rain Figure 4...
- Page 7 Li-Ion battery. This product has been marked with a symbol relating to ‘separate collection’ for all battery packs and battery pack. It will then be recycled or dismantled in order to reduce the impact on the environment. Battery packs can be hazardous for the environment and for human health since they contain hazardous substances.
- Page 8 Cordless Pruning Saw WG325E WG325E.X...
- Page 9 Kink Cordless Pruning Saw WG325E WG325E.X...
- Page 10 3-5 mm Cordless Pruning Saw WG325E WG325E.X...
- Page 11 2´ Cordless Pruning Saw WG325E WG325E.X...
- Page 12 Cordless Pruning Saw WG325E WG325E.X...
- Page 13 Cordless Pruning Saw WG325E WG325E.X...
- Page 14 Cordless Pruning Saw WG325E WG325E.X...
-
Page 15: Component List
2. COMPONENT LIST Voltage 20 V Max.** Bar length 12 cm CHAIN GUARD HOUSING-COVER KNOB Chain speed 10 m/s LOCK-OUT BUTTON Chain pitch 7.6 mm ON/OFF SWITCH Number of chain drive links GRIP AREA BATTERY PACK * Chain gauge 1.1 mm BATTERY PACK RELEASE BUTTON * Adaptive chain type WA0142... -
Page 16: Assembly
Plan your work schedule to spread any high vibration A weighted sound power = 94 dB(A) tool use across a number of days. INTENDED USE 3 dB(A) • The mini pruning saw is intended for cutting only wood and branches up to a diameter corresponding Wear ear protection. -
Page 17: Operation
This should be done by using one hand to raise the chain against the weight of the machine. 1. Set Pruning Saw on any suitable surface with oil Then tighten the Housing Cover by turning the filler cap facing upward. Housing-Cover Knob clockwise until it is tight. - Page 18 in place to avoid possible bouncing or skating (1) CHARGING YOUR BATTERY PACK (See Fig. H1, (sideways movement) of saw. (5) Guide the saw using light pressure and do not The Li-ion battery is protected against deep put excessive force on the saw, letting the saw discharging.
- Page 19 WARNING: When cutting a limb that is under SAW MAINTENANCE tension, use extreme caution. Be alert for wood Follow maintenance instructions in this manual. springing back. When wood tension is released, limb Proper cleaning of saw and chain and Guide Bar could spring back and strike operator causing maintenance can reduce chances of kickback.
-
Page 20: Environmental Protection
maintenance: advice. • Saw cuts to one side or at an angle. • Saw has to be forced through the cut. FOR BATTERY TOOLS • Inadequate supply of oil to the bar and chain. The ambient temperature range for the use and Check the condition of the Guide Bar each time the storage of tool and battery is 0°C-45°C. -
Page 21: Troubleshooting Table
7. TROUBLESHOOTING TABLE The following table gives checks and actions that you can perform if your machine does not operate correctly. If these do not identify/remedy the problem, contact your service agent. WARNING: Switch off and remove the battery pack before investigating fault. Symptom Possible Cause Remedy... - Page 22 8. DECLARATION OF CONFORMITY Positec Germany GmbH Postfach 32 02 16, 50796 Cologne, Germany Declare that the product Description Battery-powered pruning saw Type WG325E WG325E.X (3-designation of machinery, representative of battery-operated pruning saw) Function Cutting wood Complies with the following Directives: 2006/42/EC, 2014/30/EU, 2011/65/EU&(EU)2015/863, 2000/14/EC amended by 2005/88/EC...
-
Page 23: Declaration Of Conformity
DECLARATION OF CONFORMITY Positec (UK & Ireland) Ltd, PO Box 6242, Newbury, RG14 9LT, UK Declare that the product Description Battery-powered pruning saw Type WG325E WG325E.X (3-designation of machinery, representative of battery-operated pruning saw) Function Cutting wood Complies with the following regulations: Supply of Machinery (Safety) Regulations 2008 Electromagnetic Compatibility Regulations 2016 The Restriction of the Use of Certain Hazardous... - Page 24 www.worx.com Copyright © 2022, Positec. All Rights Reserved. V1-UK-WG325E WG325E.X-M-20220614...
Need help?
Do you have a question about the WG325E Series and is the answer not in the manual?
Questions and answers