Table of Contents
Advertisement
M3057-PLR Mk II Dome Camera
Configure your device
Maximize the details in an image
Important
If you maximize the details in an image, the bitrate will probably increase and you might get a reduced frame rate.
•
Make sure to select the capture mode that has the highest resolution.
•
Go to Video > Stream > General and set the compression as low as possible.
•
Below the live view image, click
•
Go to Video > Stream > H.264 and H.265 encoding > Zipstream and select Off.
Handle scenes with strong backlight
Dynamic range is the difference in light levels in an image. In some cases the difference between the darkest and the brightest
areas can be significant. The result is often an image where either the dark or the bright areas are visible. Wide dynamic range
(WDR) makes both dark and bright areas of the image visible.
Note
• WDR can cause artifacts in the image.
• WDR may not be available for all capture modes.
1. Go to Video > Image > Wide dynamic range.
2. Turn on WDR.
3. Use the Local contrast slider to adjust the amount of WDR.
4. Use the Tone mapping slider to adjust the amount of WDR.
and in Video format, select MJPEG.
Image without WDR.
Image with WDR.
9
Advertisement
Table of Contents
