Using The Self-Propel Drive; Recycling The Clippings; Stopping The Engine; Bagging The Clippings - Toro Recycler 20792 Operator's Manual

Using the Self-propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace
with you.

Stopping the Engine

Release the blade control bar.
Important: When you release the blade control bar,
both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.
9

Recycling the Clippings

Your mower comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag on page 10) before
recycling the clippings. If the side discharge chute is
on the mower, remove it and lock the side discharge
door (refer to Removing the Side Discharge Chute on
page 11) before recycling the clippings.
Important: Ensure that
the rear discharge plug
is in place before you
recycle the clippings.
m-5582

Bagging the Clippings

Use the grass bag when you want to collect grass
and leaf clippings from the lawn.
If the side discharge chute is on the mower, remove it
m-5613 and lock the side discharge door (refer to Removing
the Side Discharge Chute on page 11) before bagging
the clippings.
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.
m-5582
3353-448 Rev A
m-8103