Table of Contents
Advertisement
Projector ID
Setting
Factory Default
Reset System
Sets the projector ID for this projector (between 01~99). When multiple adjacent
projectors are in operation at the same time, switching the projector ID codes
can prevent interference from other remote controls. After the Projector ID is
set, switch to the same ID for the remote control to control this projector. See
Projector & Remote control on page 8.
Set the ID
1. Press and hold ID SET until the ID setting indicator lights up.
2. Enter the ID for the remote control (between 01~99). The remote control
ID should be the same as the corresponding projector ID.
3. The ID is saved successfully when you see the ID setting indicator starts
flickering and then blackout.
Clear the ID
1. Press and hold ID SET until the ID setting indicator lights up.
2. Press ALL to clear current ID setting of the remote control.
• The ID is cleared successfully when you see the ID setting indicator starts
flickering and then blackout.
Returns all settings to the factory preset values.
The following settings will still remain: Projector Position, 3D Keystone, Auto Vertical
Keystone, 12V Trigger, High Altitude Mode, Baud Rate, Corner Fit, Image Resizing,
Warping, Light Source Information, Security Settings, Network Settings, Projector
ID Setting.
Returns all the settings on the System main menu to the factory default values.
The following settings will still remain: Light Source Information, Security Settings,
Projector ID Setting.
Menu operation
47
Advertisement
Table of Contents
