B-K lighting HP2 Instructions Manual page 8

Accessories Installation Instructions
Faceplate with Accessories
Instructions Apply To...
Rock Guard
with Optical
Opening
1. Before installation of faceplate, clean o-ring groove
and collar of debris for a proper seal.
Failure to remove debris from groove will cause
fixture to fail and void product warranty.
4. Accessory can rotate 360° independently of
faceplate.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
B-K LIGHTING
Rock Guard Glare Shield B
2. Install faceplate using a 1/8" allen wrench and
hand-tighten the five (5) #10-24 faceplate screws
in a star pattern to 30 in-lbs. min.
Do not use a power tool to install screws. Do not
exceed 40 in-lbs.
5. When set in final position, tighten two (2) #6-32 set
screws using a 7/64" allen wrench.
Half Dome B
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • info@bklighting.com
FACEPLATE ACCESSORIES
3. Using a 7/64" allen wrench, loosen the two
(2) #6-32 set screws on the faceplate to allow
accessory to rotate freely.
RELEASE DATE
08/28/2023
HP2
REFERENCE NUMBER
INS-2882-00