Traxxas BIGFOOT N1 THE ORIGINAL MONSTER TRUCK Owner's Manual page 14

14 • TRAXXAS
TRAXXAS TQ 2.4GHz RADIO SYSTEM
CHARGE PROGRESS
x1
1 green flash
x2
2 green flashes
x3
3 green flashes
x4
4 green flashes
Solid green LED
4 4
When the LED is solid green, charging is complete.
Battery connected
LED solid green when charging is complete
LED INDICATION MEANING
Solid Red LED Ready for Charging
Slowly Flashing Green LED Charging (see Charge Progress chart)
Solid Green LED Battery Fully Charged
Flashing Red LED Charger error
Clearing errors
If there is a problem with the battery or the power adapter, the
0 - 25% charged
charger's LED will flash red. See error codes and recommended
25% - 50% charged
solutions below. If the error code repeats or will not clear, contact
50% - 75% charged
Traxxas Customer Support.
75% or more charged
LED INDICATION
100% charged
Charging tips
• The charger MUST be connected to USB-C power BEFORE connecting
the battery. If the battery is connected before connecting to USB-C
power, the charger will show an error (red LED flashes 6 times and
repeats). To correct, unplug the battery and the charger. Plug in the
charger to USB-C power, and then connect the battery to be charged.
• The charger requires 10W or greater output from the USB-C source to
operate.
• The charge output current varies depending on the available power
from the USB-C source. To ensure the maximum charge rate, use a
USB-C power source rated at 45 watts (capable of 2.25 amps at 20
volts). Traxxas USB-C AC Power Adapter (part #2912) and Power Cable
(part #2916) are designed to deliver the full 4-amp charge output
from the charger.
MEANING
Disconnect battery and USB-C power source.
x1
Power source error
Check power source for compatibility.
x2
Battery voltage is too low Disconnect and discontinue use of battery.
Disconnect battery. If battery is hot,
The charger timer has
x3
discontinue charger use. If battery is not hot,
expired
reconnect to continue charging.
The internal charger Disconnect charger and allow charger
x4
temperature is too high to cool.
Disconnect battery and power adapter.
x5
Power adapter error
Adapter is not sufficient to support charging.
Battery connected to
Disconnect battery; wait for solid red LED on
x6
charger before USB-C
charger before reconnecting battery.
power supplied.
Disconnect battery; battery is not
x7
Battery voltage is too high
compatible with the charger.
Charger has detected Disconnect battery and power adapter.
an internal error Discontinue charger use.
SOLUTION