Table of Contents
Advertisement
Figure 96
1. Deck-lift pedal
2. Height-of-cut pin
6.
Insert the height-adjustment pin into the 7.6 cm
(3 inches) cutting-height location.
7.
Release the transport lock and allow the deck to
lower to the cutting height.
8.
Raise the discharge chute.
9.
On both sides of the deck, measure from the
level surface to the front tip of the blade (Postion
A) as shown in
Figure
Note:
The measurement should read 7.6 mm
(3 inches)
g027343
3. Transport lock
97.
1. 7.6 cm (3 inch) at position
A is correct
2. 8.3 cm (3-1/4 inch) at
position B is correct
10.
Fine-tune the adjustment nut on the front
deck-lift assembly by turning it
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease the
height, turn the nut counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, you
can use the single-point adjustment to gain
more adjustment.
1. Whizlock nut
2. Adjuster screw
11.
To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure
99).
64
Figure 97
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
(Figure
Figure 98
3. Jam nut
4. Yoke
g009196
98).
g010251
Advertisement
Table of Contents
