Kruger SECOMAT 275 Operating Instructions Manual page 17

INSTRUCTIONS
Transportation and storage
The machine should whenever pos-
sible be transported in an upright posi-
tion. If it is transported on its side, the
machine must be placed in an upright
position and left for at least two hours
before being connected to the mains
and started.
If the machine is not going to be used for
a significant period of time, the water
tank and housing must be cleaned with
a damp cloth and then rubbed dry be-
fore storage. The machine should then
be packed in its original box.
Fitting the washing line
For the best drying results, fit the wash-
ing line as described below:
Wrong:
The washing facing the drier obstructs
the flow of air so that the washing to-
wards the back takes much longer to
dry.
Good:
In this case the air can circulate and is
able to reach the items at the back.
Best:
The Sunline System has been specially
developed by Krüger for its Secomat
range of clothes driers and gives the
shortest drying times.
Installing the clothes drier
• Fit the enclosed fixing rail to the wall
60 cm below the clothes line (if pos-
sible, on an internal wall to prevent
the build-up of condensation behind
the machine)
• Attach the machine to this rail and
secure with the left and right-hand
screws
• Ensure a safe distance of 8 cm to flam-
mable parts
Operating temperatures
275 E: min. +15°C, max. +30°C
275 AH: min. +8°C, max. +30°C
In model E, the heating element is not
activated. Therefore, the appliance only
operates properly within a temperature
range between +15°C and +30°C. If the
appliance is operated in a temperature
range below 15°C, an icing of the cool-
ing element may occur. In this case, the
heating element has to be activated by
the service technician. This operating
mode should be avoided, as the power
consumption increases during operation
with the heating element active. The
Model AH is equipped with a heating ele-
ment, which is automatically switched