Table of Contents
Advertisement
Hood connection
en
Connecting via your home network
You require a router that has WPS functionality.
You require access to your router.If you do not have
this, follow the steps for "Direct connection".
When you begin, make sure that the extractor hood is
connected to the app or is on your home network.
Switch on the hob.
1.
Touch and hold the
2.
The product information is displayed.
Touch the
symbol repeatedly until
t
3.
displayed alternately.
(not connected) or
‹
network) will be lit on the hotplate display.
Set the value
‚
in the settings area.
4.
flashes in the hotplate display.
‚
If the appliance is not yet connected to your home
5.
network, press the WPS button on the router within
the next 2 minutes.
The hob will be connected to your home network
and the value
ƒ
will appear on the hotplate display.
The process of connecting to the extractor hood
starts automatically and is active for 2 minutes.
If the appliance is already connected to your home
network, proceed to the next step.
Initiate the process for connecting to the extractor
6.
hood.
Once the hob is connected to the extractor hood, the
value
appears in the hotplate display. After you exit
„
the settings menu, the symbols for the hob-based hood
controls are displayed in the hob's control panel.
Note:
Connection can only be established when both
appliances are connected to your home network and
the connection process has been initiated for both of
them. If the connection process has already timed out
for one of the two appliances, try to connect again
(basic settings,
setting).
™‚‡
Disconnecting from the network
D i s c o n n e c t i n g f r o m t h e n e t w o r k
You can reset the connections you have saved for your
home network and extractor hood at any time.
Switch on the hob.
1.
Touch and hold the
2.
The product information is displayed.
Touch the
t
symbol repeatedly until
3.
displayed alternately.
Set the
value on the control panel.
‹
4.
The connection has been restored.
36
symbol for four seconds.
t
and
™
(connected to home
ƒ
t
symbol for four seconds.
™
and
Control the hood via the hob
In the basic settings of your hob you can adjust the
behaviour of your extractor hood depending on the
switch-on/off of the hob or individual cooking zones.
~ "Hood control settings" on page 37
You can select other settings using the control panel.
Setting the fan
Activation
are
‚‡
Touch the
1.
Select the fan setting.
2.
You can choose between the levels 1, 2 and 3. To
select the levels Boost and PowerBoost, touch
buttons 4 or 5, or touch the
until the required intensive level is set.
The fan has been activated.
Deactivating
Touch the
1.
Select fan setting 0.
2.
The fan has been deactivated.
Setting automatic mode
Activation
Touch the
control panel.
The fan starts up automatically when steam is
produced.
Deactivating
Touch the
select another fan level.
Automatic mode is deactivated.
Setting the hood lighting
You can switch the hood light on and off via the hob's
control panel.
Touch the
‚‡
are
symbol.
:
á
symbol.
:
symbol until the
symbol appears on the
:
>
symbol until the
symbol goes out, or
:
>
symbol.
<
button repeatedly
Advertisement
Table of Contents
