Advertisement
Door Lock/s
The fridge may be fitted with bracket locks or key locks, located above or below each door. Bracket locks require a lock (padlock or
similar) through the brackets to lock the door. Key locks can be locked with the supplied key.
Electronic Controller
The electronic controller regulates the fridge's temperature, signals alarms and captures operational information.
The fridge temperature is set at the factory for storing perishable product (all shelves maintain temperatures below
5°C).
To customise the fridge settings to your requirements and view historical data, download the SKOPE-connect app
from the Google Play Store or Apple App Store, and connect via Bluetooth
Lights
The fridge lights switch on and off automatically depending on fridge use.
Cleaning
Ensure the fridge is unplugged from the power supply before cleaning.
Wipe the inside and outside of the cabinet with a damp cloth, taking care to keep moisture away from electrical parts.
The condenser coil must be kept clean. SKOPE strongly urges monthly cleaning of the condenser coil and air filter (optional air filter
available on BME only). Do NOT use hard or sharp tools to clean the coil as these may cause damage.
TME and SKT – Clean the Coil
Coil
Tab and notch
PRN80133 Rev. 1.8 Nov. 2022
Fridge
1.
Unplug the fridge from the power
supply.
2. Remove the front panel from the top
of the cabinet. Lit sign panels also
need to be unplugged.
3.
Brush the condenser coil with a soft
brush to remove any dust and fluff.
4. Refit the sign assembly and
reconnect to the power supply.
Important
When refitting, ensure the tabs on
the back of the sign are located in
the notches on top of the cabinet,
and that the sign is pushed fully in
and secure.
®
.
BME and SKB – Clean the Filter
Grille
Grille
Finger loop
BME and SKB – Clean the Coil
Coil
Refrigeration
Refrigeration
1.
Rotate the grille at the bottom of the
front kick panel out to gain access to
the filter.
2. To remove the filter, use the finger
loops to pull the filter up and detach
from the front kick panel.
3.
Clean the filter with a vacuum
cleaner, wash with cold water and
shake excess water off before
refitting. Do not apply hot water,
blow dry or place in a dishwasher. If
necessary, discard the air filter and
refit a new one.
4. To refit the filter, insert it up into the
front kick panel vent with the finger
loops facing out, then clip the into
the slots on the bottom face of the
front kick panel vent.
1.
Unplug the fridge from the power
supply.
2. Remove the front kick panel from the
front of the cabinet.
3.
Brush the condenser coil with a soft
brush to remove any dust and fluff.
4. Refit the front panel and reconnect
to the power supply.
0070513784
Advertisement
