Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS
WARNING: To avoid fire or electric shock, make sure power is OFF before beginning installation.
!
IMPORTANT: Installation should be made by a licensed electrician. This device is to be installed in a wall box measuring at least
3 in. x 2 in. x 2-1/2 in. (7.6 x 5 x 6.3 cm) (standard single gang electrical wall box) and wired in accordance with National Electrical Code.
Straighten each wire and strip
3/4 in. (1.9 cm) of insulation
from each wire.
1.
Insert the ground (green) or bare wire(s) into the hole(s)
labeled G (near green screw).
2.
Insert the two neutral (white) wires into the holes labeled
N (near silver screw).
3.
Insert the hot (black) wire into the hole labeled L-I
(near brass screw).
4.
Insert the load (black/red) wire into the hole labeled
L-O (near brass screw). The screw terminal accepts
14AWG-12AWG copper wire (12AWG maximum).
5. Tighten all screws firmly.
6.
Carefully fold wires into wall box and mount Wall Switch
into wall box using mounting screws (CC), then attach a
standard decorator-style wall plate (not included) using
screws (DD).
7.
Restore power by flipping the circuit breaker to the ON
position or re-installing the fuse to the circuit.
3/4" (1.9 cm)
Ground
(Green)
Neutral
(White)
Neutral
(White)
Hot wire
(Black)
Load wire
(Black/Red)
CC
CC
WALL
DD
DD
Made in China
Advertisement
