Table of Contents
Advertisement
Problem
The indicator light
comes on. and
continue to flash after a
programme has been
cancelled despite
thorough cleaning.
The indicator light
comes on after a
programme has been
cancelled and a signal
sounds.
and another number
combination flash after
a programme has been
cancelled, a signal
sounds.
: lights up and the
programme has been
cancelled, a signal
sounds.
Possible cause and remedy
The plinth filter looks clean after thorough cleaning.
However, the programme is terminated again and the
error message appears again. There are probably still
deeper residues which could not be removed.
To deactivate the message, turn the programme
selector to the position.
Check all of the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
in "Problem solving guide - Checking the heat
exchanger".
The plinth filter is clogged on a deeper level.
Check the plinth filter. Follow the instructions in
"Problem solving guide - Replacing the plinth
filter".
If the plinth filter is not deformed or defective, you
can regenerate it in the washing machine. Follow
the instructions in "Problem solving guide -
Regenerating the plinth filter".
The condensed water container is full or there is a
kink in the drain hose.
To switch off the indicator light, open and close
the door (with the tumble dryer switched on).
Empty the condensed water container.
Check the drain hose.
See "Cleaning and care".
There is no obvious cause.
Switch the dryer off and then on again.
Start a programme.
If the programme terminates again with the same
error message, then there is a fault. Contact Miele.
The laundry is unevenly distributed or has rolled up.
Untangle the laundry and remove a few items, if
necessary.
Switch the dryer off and then on again.
Start a programme.
Problem solving guide
51
Advertisement
Table of Contents
