Soundstream Rubicon 1002 Owner's Manual And Installation Manual page 5

♦ ♦ ♦ ♦ ♦
Drive Delay I I ™ Amplifier section powers up 2 to 3 seconds after the
power supply eliminating turn-on and off pops. The turn off process is
reversed: Amplifier section turns off first, followed by the power supply.
♦ ♦ ♦ ♦ ♦
Output Clipping Indicators (502 and 1002) indicate clipping on the
output stage of the amplifier. Monitoring the clipping indicators allows
the user to achieve maximum Sound Pressure Level without clipping
the amplifier.
♦ Auto High Curren t ™ automatically matches the amplifier to the load
being driven allowing greater system flexibility, greater output, higher
reliability, and high efficiency 1 ohm (stereo) operation.
♦ ♦ ♦ ♦ ♦
Chassisin k ™ All transistors are ideally located and sandwiched be-
tween the circuit board and the heatsink to provide cool efficient ampli-
fier operation.
♦ ♦ ♦ ♦ ♦
Fully Balanced 6-pin DIN Input (502 and 1002) for professional-qual-
ity performance and noise cancellation. The 6-pin DIN plug carries (±)
signal information for Left and Right channels, audio ground, and ± 15
Vdc to operate the Soundstream BLT / BLT4 Balanced Line Transmit-
ters.
♦ ♦ ♦ ♦ ♦
Continuously Variable Crossover Networks : 12 dB/Octave highpass
variable from 70 to 160 Hz, and 24 dB/Octave lowpass crossovers vari-
able from 55 to 220 Hz on (502 and 1002 ). 12 dB/Octave highpass
variable from 50 to 200 Hz, and 24 dB/Octave lowpass crossovers vari-
able from 40 to 160 Hz on (302).
♦ ♦ ♦ ♦ ♦
Flexible Dual Input Level Control (502 and 1002) allows 300 mV to
5 V input sensitivity. Separate Left and Right level controls allow user to
optimize system level control.
♦ ♦ ♦ ♦ ♦
Removable Front Spoiler allows for stealth installation of RCA, Bal-
anced Line, Speaker and Power wiring.
5