Compressor Modes - Endorphines COCKPIT 2 Manual

MIX OUT
2. is post master volume knob audio output, compatible with other
Mix Bus modules.
STEREO BALANCED LINE OUT
3.
Jacks IO v2 board. Let's you route the final post master volume knob output
straight to the TRS jacks on the Intellijel cases.
POWER CONNECTOR
4.
connector.

COMPRESSOR MODES

The built in compressor features 3 different modes of dynamic processing of audio
signals.
To switch different modes, hold press all 4 encoders for longer than 1 second until
you see the SIDECHAIN LED (7) blink either 1, 2 or 3 times showing the selected
mode. On every startup that LED blinks same amount of times reminding the
selected mode. Selected mode automatically saves after a few seconds of idle
Cockpit use.
DUCKING WITH CV:
1.
0 to approximately +5V. Everything that goes above +5V is being saturated, and
everything that is below zero will be cut off. The SIDECHAIN KNOB adjusts the
level of ducking. Adjust it to the desired pumping level/intensity. The blue LED near
that knob shows the amplitude of the input signal and lights up when the ducking
level increases. TIPP: When no plug is inserted into the sidechain jack, the sum of
all four channels is sent to the sidechain input of the ducking compressor. That
connection may seem a bit experimental (since the channel generates a CV
envelope from the full mix and it may sound more like amplitude modulation),
however at some point it may bring interesting results.
DUCKING WITH AUDIO:
2.
times with an envelope follower at the input. Now you may simply input a sound
source (a kick or snare drum for instance – at a consumer line level – approx. 1Vpp)
and the CV will be extracted from that audio source and applied to the channels you
assigned to the ducking by pressing­and­holding the encoder for over one second
(just as you did in the CV in mode described above). Tipp: If the ducking effect
seems too hefty, it may be that the audio you want to use is too 'hot' – attenuating
may help.
DUCKING WITH TRIGGERS:
3.
standard modular level (everything that is higher approx. 1V is recognized as on and
is 6 pin connector for the Intellijel
is 10 pin typical +/­12V eurorack power
The input of the COCKPIT accepts unipolar CV from
The sidechain input is amplified by approx. 10
The sidechain input accepts triggers in