Using The Wall-Mounted Door Control; To Open The Door Manually - Craftsman 139.53915D Owner's Manual

Using the Wall-Mounted Door Control

THE MOTION DETECTING CONTROL CONSOLE
Press the push bar to open or close the door. Press again to
reverse the door during the closing cycle or
to stop the door while it's opening.
This door control contains a motion detector
that will automatically turn on the light when
it detects a person entering the garage. This
feature can be easily turned off for extended
work light use.
Light feature
Press the Light button to turn the opener light on or off. It will not
control the opener lights when the door is in motion. If you turn it
on and then activate the opener, the light will remain on for 4-1/2
minutes. Press again to turn it off sooner. The 4-1/2 minute
interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as
follows: Press and hold the Lock button until the light blinks
(about 10 seconds). A single blink indicates that the timer is reset
to 1-1/2 minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat again for a
3-1/2 minute interval, etc., up to a maximum of four blinks and
4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-held remote
controls. However, the door will open and close from the Door
Control, the Outdoor Key Switch and the Keyless Entry
Accessories.
To activate, press and hold the Lock button for 2 seconds. The
push button light will flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds.
The push button light will stop flashing. The Lock feature will also
turn off whenever the "learn" button on the motor unit panel is
activated.
Additional feature when used with the 3-Function hand-held
remote
To control the opener lights:
In addition to operating the door, you may program the remote to
operate the lights.
1. With the door closed, press and hold a
small remote button that you want to
control the light.
2. Press and hold the Light button on the door
control.
3. While holding the Light button, press and hold the Lock button
on the door control.
4. After the opener lights flash, release all buttons.

To Open the Door Manually

To prevent possible SERIOUS INJURY or DEATH from a falling
garage door:
Push
Bar
• If possible, use emergency release handle to disengage
trolley ONLY when garage door is CLOSED. Weak or broken
Lock springs or unbalanced door could result in an open door
Button
falling rapidly and/or unexpectedly.
Light
Button
• NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope knot
becomes untied, you could fall.
DISCONNECT THE TROLLEY:
The door should be fully closed if
possible. Pull down on the
emergency release handle (so that
the trolley release arm snaps into a
vertical position) and lift the door
manually. The lockout feature
prevents the trolley from
reconnecting automatically, and the
door can be raised and lowered
manually as often as necessary.
TO RE-CONNECT THE TROLLEY:
Pull the emergency release handle
toward the opener at an angle so
that the trolley release arm is
horizontal. The trolley will
reconnect on the next UP or DOWN
operation, either manually or by
using the door control or remote.
31
Trolley
Trolley
Release Arm
(In Manual
Disconnect
Position)
Lockout position
(Manual disconnect)
Trolley
Trolley
Release
Arm
Emergency
Release Handle
(Down and Back)
To reconnect