IMPORTANT PLEASE READ All products manufactured and supplied by BAGNODESIGN are fit for purpose as long as they are Installed, used correctly, cleaned and receive regular maintenance in accordance with these instructions ... Remove all packaging and check the product for damage or missing parts before commencing with the installation.
Page 4
Tools Required (Not supplied) Always flush pipework before installation Tap comes with pre-installed flexible hoses. Electrical Cable...
Page 5
Technical Specification Description Electronic faucet Power DC: 6V (4AA alkaline battery) Power Consumption DC: Standby:≤ 0.2mW Sensing distance 13-4 cm Water Pressure 0,5 Bar - 5 Bar Temperature 20°- 60° Ø of inlet pipet G1/2” Flux 7.6 L/min...
First time use Automatically setting the initial value of the sensing distance : The sensor first scans the use environment 8 times with power on to set the sensing distance. ATTENTION : do not shake hands or objects at the sensor window during the flash After setting the initial value of the sensing distance, the sensor should be not used for 3 minutes.
Temperature setting Sensing Distance 13 cm 13 cm Timeout protection: when the continuous use time exceeds 55' seconds, the sensor will automatically turn off the water, so as to avoid the phenomenon of continuous water flow caused by foreign objects in the sensor' range and waste of water.
Page 10
PROBLEM SOLUTION Lack of water supply Dead battery Replace the batteries as shown on page 2(A) Electrical problem > Disconnect the battery > Check the connection > Check the integrity of the cable Water keeps on running for Dirty sensor Clean the sensor as shown on more than 1minute without page 3 (C)