Related Manuals for Videomitter MIT500
Summary of Contents for Videomitter MIT500
- Page 1 Instruction Manual MIT500 Wireless 2MP AHD Transmission © 2023 System Q Ltd VideoMitter.com...
-
Page 2: Table Of Contents
MIT500 Table of Contents Introduction User Information Connections & Powering Antenna & Signal Pairing Troubleshooting Quick Links Specifications Conditions General Company Disclaimer ..................9 WEEE Declaration ......................9 Copyright ........................9 © 2023 System Q Ltd VideoMitter.com... -
Page 3: Introduction
· Do not install or use the device if the power cable or video connections are damaged. · Do not use alcohol or solvents to clean the product, only clean using a damp cloth. © 2023 System Q Ltd VideoMitter.com... -
Page 4: Connections & Powering
MIT500 Connections & Powering The MegaMitters need powering with a suitable regulated 12V DC power supply. Both the TX and RX need powering individually. When they are powered up a red power light will come on. The Transmitter (TX) unit has the following connections: 1. - Page 5 To power the camera via power pass-through connect the power out cable (1) on the transmitter to your camera’s power in female lead. Note - If you press and hold the reset button by mistake you will need to re-pair the units, see Pairing © 2023 System Q Ltd VideoMitter.com...
-
Page 6: Antenna & Signal
MIT500 Antenna & Signal The small antenna simply screws on to the top of the MegaMitters. Optional antennas are available to increase transmission range. To see our full range of aerials please visit; https://systemq.com/store/Category/Wireless-CCTV-Video-Antennas Signal Different site conditions will affect the signal and range of the MegaMitters. -
Page 7: Pairing
3. Once pairing is complete both Link LEDs will display solid Green. If a monitor is connected to the RECEIVER it will display a signal strength bar at the top left hand corner of the display. © 2023 System Q Ltd VideoMitter.com... -
Page 8: Troubleshooting
MIT500 Troubleshooting If no video signal is displayed but the 27/07/2023 VideoMitter.com... -
Page 9: Quick Links
Index Quick Links © 2023 System Q Ltd VideoMitter.com... -
Page 10: Specifications
MIT500 Specifications Frequency 2.4Ghz Video Format CVBS (PAL/NTSC) / AHD 720p / AHD 1080p Range 100m (as supplied) Max Range 1Km (with additional aerials) Audio IP Rating IP66 (providing connections are made IP66) Antenna RP-SMA Video Connection Input Voltage 12V DC... -
Page 11: Conditions
WEE/CG0783SS collection point as defined by your local council. 9.3 Copyright © Copyright 2023 Zip is a registered trademark of System Q Ltd, Chesterfield. Derbyshire. S40 2WB © 2023 System Q Ltd VideoMitter.com...
Need help?
Do you have a question about the MIT500 and is the answer not in the manual?
Questions and answers