Sound Storm D3000SL User Manual

Sound Storm D3000SL User Manual

Digital mono block amplifier

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the D3000SL and is the answer not in the manual?

Questions and answers

Summary of Contents for Sound Storm D3000SL

  • Page 1 Congratulations! Specifications Features Installation Low Level Input /Speaker / Power Wiring Bridging Two Amplifiers Electrical Wiring Mounting the Amplifier Precautions Troubleshooting - 2 -...
  • Page 2: Specifications

    The Power Supply incorporated into SLADE class-D amplifier is a DC to DC Switching power supply designed to have adequate headroom for even the most Demanding peak and dynamic range found on todays Cds and recordings. Thank you for making SOUND STORM your choice for car audio equipment! Specifications MODEL...
  • Page 3 D3000SL Rear - 5 - Installation Things To Remember When Installing Your D3000SL: This amplifier designed philosophy and mode of regulation requires that proper installation and load impedance instructions be adhered to at all times. Minimum impedance recommend is 1 Ohm.
  • Page 4 Low Level Inputs / Speaker / Power Wiring NOTE: NOTE: The amplifier may receive its input signal from a head unit or signal The amplifier may receive its input signal from a head unit or signal processors subwoofer output. processors subwoofer output. - 7 - Bridging Two Amplifier (BRIDGED SWITCH : MASTER POSITION)
  • Page 5 Fuses protect both the amplifier and the electrical system of your vehicle from faulty conditions. If you must replace the fuse in your SLADE D3000SL amplifier, use a fuse of exactly the same type and rating. A different type or rating may result in damage or cause a fire.
  • Page 6: Troubleshooting

    Troubleshooting Amplifier will not power up. Check for good ground connection. Check that Remote Input (turn-on) at amplifier has at least 3 volts DC. Check that there is battery power on the + terminal. Check all fuses. Check that Protection LED is not lit. If it is lit, shut off amplifier briefly and then repower it.

Table of Contents