Download Print this page

The First Wash Cycle; Technical Data - Indesit BWA 71052 Instructions For Use Manual

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Connecting the drain hose
should not be underwater.
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose
and must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electri-
city socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
• the power supply voltage falls within the va-
lues indicated in the Technical data table (see
opposite);
• the socket is compatible with the plug of the
washing machine. If this is not the case, repla-
ce the socket or the plug.
! The washing machine must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washing machine has been instal-
led, the electricity socket must remain within
easy reach.
Connect the drain
hose, without bending
it, to a drain duct or
a wall drain situated
between 65 and 100
cm from the floor;
Alternatively, place
the drain hose over
the edge of a wa-
shbasin or bathtub,
by fastening the
guide
(which
can be purchased at
the technical assi-
stance centre) to the
tap (see figure). The
free end of the hose
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be repla-
ced by authorised technicians.
Warning! The company shall not be held re-
sponsible in the event that these standards are
not observed.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using the
wash cycle "Auto Clean" (see "Cleaning the
washing machine").

Technical data

Model
BWA 71052
width 59.5 cm
Dimensions
height 85 cm
depth 54 cm
Capacity
from 1 to 7 kg
please refer to the technical
Electrical
data plate fixed to the ma-
connections
chine
maximum pressure
1 MPa (10 bar)
Water
minimum pressure
connections
0.05 MPa (0.5 bar)
drum capacity 52 litres
Spin speed
up to 1000 rotations per minute
Test wash
cycles in
accordance
Programme 9:
with re-
Eco Cotton 60°.
gulations
Programme 9:
Eco Cotton 40°.
1061/2010
and
1015/2010.
This appliance conforms to
the following EC Directives:
- EMC 2014/30/EU (Electro-
magnetic Compatibility)
- LVD 2014/35/EU (Low
Voltage)
- 2012/19/EU - (WEEE)
GB
3

Advertisement

loading