Faults And Solutions - Veripart MAGNETRON VPMAG25B Instructions Manual

6

FAULTS AND SOLUTIONS

The following cases are not always a fault. See the possible solutions before asking for service.
Problem
The TV signal is disturbed
while using the microwave.
The lighting of the oven space
is weak.
Steam will deposit on the
door. / Hot air comes out of
the vents.
The microwave accidentally
started without food in the
oven.
The microwave does not turn
on.
The microwave does not heat.
Sparks and crackling sounds
inside the oven.
Cause
ATTENTION! This is normal and not a
fault or defect. The microwave is too close
to the TV.
ATTENTION! This is normal and not a
fault or defect. When cooking with a low
microwave power, the lighting of the oven
room may burn weaker.
ATTENTION! This is normal and not a
fault or defect. When cooked, hot steam
can come off the food. Most steam leaves
the appliance through the vents, but steam
can also deposit on a cool surface such as
the door.
-
The appliance is not powered.
The fuse of the appliance has been blown.
The door is not completely closed.
There are unauthorised materials in the
oven such as:
• metals from decorative edges on
plates and crockery, for example,
metal parts of kitchenware or metal
cutlery
• aluminium foil
53
Cause
Place the microwave further away
from the TV.
-
-
Immediately turn off the appliance
by pressing the Stop/Cancel
button twice.
WARNING! Never switch on the
microwave without food in the oven.
1. Check that the plug is in the
socket and that the cable or
plug is not damaged.
2. Check that the RCD is switched
on.
3. Check that there is no power
failure.
Please contact customer service. See
Foreword for the contact details.
Close the microwave door.
1. Turn the microwave off
immediately.
2. Wait until the contents of the
oven has cooled down.
3. Open the door and remove
unauthorised materials.