Table of Contents
Advertisement
Troubleshooting
Before asking to have the projector repaired, try to diagnose the problem, following the
instructions below.
Symptoms
The power is not turned
on.
No image.
On-screen display does
not appear.
The aspect ratio of the
display is not right/the
image is displayed
smaller /a portion of
image does not appear.
The image is a
trapezoid.
Remedy
Check if the AC power cord is firmly connected.
When the "Control Key Lock" is set to "On," you cannot turn
on the projector using the ?/1 key on the projector.
If the lamp or lamp cover is not attached securely, the projector
cannot be turned on.
Check if the connecting cable is connected to external
equipment firmly.
Check the computer signal is set for output to an external
monitor only. If you set your computer to output to both the
computer's display and an external monitor, the external
monitor image may not be displayed properly. Set your
computer to output to only an external monitor.
Check if the input source is correctly selected.
Check if the picture is muted.
The on-screen display does not appear when "Status" in the
Operation menu is set to "Off."
The image may not display correctly because the input signal
cannot be judged correctly. In this case, set "Aspect" manually.
The images become trapezoidal because of the projection
angle. In this case, you can correct the trapezoidal distortion,
using a Keystone feature.
When the "V Keystone" is set to "Manual," the keystone
feature does not work automatically. Set "V Keystone" to
*1
"Auto"
or "Manual" to set manually.
When the projector is installed on an uneven surface, the
*1
keystone feature
may not work properly. In this case, select
"Manual" to set "V Keystone" manually.
Page
–
25
33
13
15
15
12
25
11,
22, 23
11,
18, 27
11,
18, 27
11,
18, 27
31
Troubleshooting
Advertisement
Table of Contents
