Advertisement
Available languages
Available languages
WARNING: IMPORTANT!
BEFORE LIGHTING
Inspect the gas supply hose prior to turning the gas "ON". If
there is evidence of cuts, wear, or abrasion, it must be
replaced prior to use. Do not use the grill if the odor of gas is
present. Only the pressure regulator and hose assembly
supplied with the unit should be used.
Never substitute regulators and hose assembly for those
supplied with the grill. If a replacement is necessary, contact
the manufacturer for proper replacement. The replacement
must be that specified in the manual.
WARNING
Always keep your face and body as far away from the
burner as possible when lighting.
TO LIGHT THE MAIN
Make sure all knobs are off then turn on the gas supply from
the LP (Liquid Propane) tank. Always keep your face and
body as far from the grill as possible when lighting.
For outdoor grills using gas supply source other than a 20 lb
(9.1 kg) LP gas fuel tank, open the manual shutoff valve in
the gas supply line. The valve is open when the handle is
parallel to the gas pipe.
To light your main burner, push and turn main burner control
knob to "
", at the same time, press and hold electronic
ignition button to light the burner. Once the burner is lit,
release the electronic ignition button and knob. If the burner
does not light wait 5 minutes for any excess gas to dissipate
and then retry.
1. If the burner will not light after several
attempts, then the burner can be match lit,
before using the match allow 5 minutes for
any accumulated gas to dissipate.
2. Clip a match on one end of the lighting rod.
3. Light match.
4. Hold lighting rod and insert lighted match
right next to the burner ports or ceramic file.
5. Push and turn the designated control knob
to "
".
6. Burner should ignite immediately.
A. Closed valve
B. Open valve
11
Lighting Instructions
Keep a spray bottle of soapy water near the gas
supply valve and check the connections before
each use.
Do not attempt to light the grill if odor of gas is
present. Call for service 1-800-913-8999,
language spoken: English, French, Spanish,
8 a.m.-5 p.m., PST. Monday-Friday.
Each burner is adjusted prior to shipment;
however, variations in the local gas supply may
make minor adjustments necessary.
CAUTIONS
Place dust cap on cylinder valve outlet when the
cylinder is not in use. Only install the type of dust cap
on the cylinder valve outlet that is provided with the
cylinder valve. Other types of caps or plugs may result
in leakage of propane.
The gas must be turned off at the supply cylinder
when the unit is not in use.
If the appliance is stored indoors the cylinder must be
disconnected and removed from the appliance.
Cylinders must be stored outdoors in a well-ventilated
area out of the reach of children.
Match Lighting
Advertisement
Chapters
