Advertisement
Installation
Tiling guide
There is a spacer plate incorporated into the end of the tiling guide. Remove this by
snapping it at the four points. Remove any burrs.
Extension rod
Screw the extension rod onto the spindle
of the cartridge.
12
Spacer plate
Spacer plate
Step of collar
Insert the spacer plate into the step of the
collar.
Installation
Measure the distance (X mm) the rod protrudes from the level of the spacer plate
and then unscrew the rod and remove the spacer plate. Note: Ensure the cartridge is
pushed in (the off position).
X mm
Cut away the measured distance
(X mm)
from the end of the rod as well as the
2 screws
provided with the ZON-143 trim.
X mm
Rod
Spacer plate
Cap
Extension rod
Hex key
Screw the cap onto the rod until it's flush
and tighten the grub screw on the cap
using the smaller hex key provided with
the ZON-128.
13
Advertisement
