Download Print this page

Accessories - Uniden BT-955 User Manual

Bluetooth speaker headset

Advertisement

and go off after fully charged.
Step 3. It will take around 1 to 2 hours for recharging battery.
Step 4. Please remove the power cable when completed.

Accessories

USB power input Cable (3.5mm to USB): 100 cm ± 5 cm
AUX in Cable (3.5mm to 3.5mm) : 100 cm ± 5 cm
User manual
The contents are subject to change without prior notice due to
product improvement and specification changes.
FCC statement:
" This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation."
FCC Caution:
"Changes or modifications not expressly approved by the part responsible for
compliance could void the user's authority to operate the equipment."
FCC Statement:
"This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help."
8

Advertisement

loading